![]() ![]() This is my opinion only and I truly wanted to say thank you for making a change to Rogers, thank you to the Devs and Engineers that worked on this. ![]() ![]() I have yet to test if bridge mode works now and has been fixed on my side, as it wasn't working before, but to be honest, if this is the speeds and consistency I will continue to have, then I will not even bridge my modem as this is optimal! I know that not everyone may have the same results and I do agree we have been dealing with a lot of frustrations and ups and downs for some time, but this to me is a HUGE improvement and makes me feel that the money I am spending for service is worth it and justified. Slightly higher on Ethernet, but not even close to this speed! This is the result consistent for my connection after the update to 36T5.īefore this, it was closer to 500ish with around 15-17 ping, upload about the same. Not only that, the speeds are where they should be both on wifi and ethernet using only the rogers modem itself. Today when I woke up, both myself and my wife typically work from home and we noticed a huge improvement in our speeds and even the wifi range. The client is sent the requested web page based on applied policy.I wanted to chime in here too with some feedback, I for one am very happy with my results, last night I got updated to 2.0.10.36T5 overnight seamlessly.If the request should be blocked, Umbrella will return an encrypted DNS response pointing to the Umbrella block page.If the request is allowed, Umbrella will return an encrypted DNS response with the appropriate IP.After arriving at the Umbrella endpoint, the DNS query is decrypted and checked against the appropriate Umbrella policy (based on the attached identifier) to determine if it should be allowed or not.Meraki then encrypts the DNS query using DNSCrypt, source NAT's the packet to the MR management IP, and redirects it to the appropriate Umbrella endpoint.Meraki intercepts the DNS query and attaches an identifier to identify which Umbrella policy this request should be checked against.This section of the article describes the expected traffic flow of DNS traffic from clients after an SSID or group policy has been successfully linked to an Umbrella filtering policy. More information can be found in Cisco Umbrella's Policy Precedencedocumentation. ![]() The policy list in Umbrella is read in a top-down order and once a match is found for the device ID, no other policies will be evaluated. Once a policy is assigned to a network device (SSID/group policy) in the Umbrella dashboard, any policies below the one selected for the network device will not be checked against. If, for example, an admin were to assign a different policy to a network device (read: Meraki group policy or SSID) in the Umbrella dashboard, that change would be reflected in the Meraki dashboard, however the policy would still show as indirectly applied because it was not applied from the Meraki dashboard. This shows in the Meraki dashboard as Default Policy (indirectly applied) because the default Umbrella policy was not specifically selected from the Meraki dashboard. When a Meraki SSID is initially linked, it will inherit the default Umbrella Policy, which will be the last policy in Umbrella's ordered list. NOTE: The order that policies are listed in Umbrella is important. This can be viewed by logging into the Umbrella dashboard and navigating to Policies > Policy list. Once a policy is assigned to a network device (SSID/group policy) in the Umbrella dashboard, any policies below the one selected for the network device will not be checked against. If, for example, an admin were to assign a different policy to a network device (read: Meraki group policy or SSID) in the Umbrella dashboard, that change would be reflected in the Meraki dashboard, however, the policy would still show as indirectly applied because it was not applied from the Meraki dashboard. When a Meraki group policy is initially linked it will inherit the default Umbrella policy, which will be the last policy in Umbrella's ordered list. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |